Hi everyone,
I have been having quite a lot of blockage issues with the sink waste pipe and so decided to take the waste pipe to the drain outside. So i got my DIY hat on and purchased a core drill to make the whole in the wall to feed the waste pipe out. It was a learning curve but finally managed to get it done.
Then I had to figure out how to add to the sink/waste pipe in order to add an additional pipe to feed the waste pipe outside. The setup at the moment is this;
Two sinks => connects to U-Bend => connects to waste pipe which goes around the kitchen and out of the main waste pipe.
I wanted the existing waste pipe to still have a connection as the washing machine and dish washer is connected to it and thought if it ever gets block on the normal one, it can still come out from the "new" waste pipe.
OK cut the story short, I am totally confused on which connection to use. I bought the Push Fit Tee but it doesnt seem to connect to the existing pipes. Can someone please help me to understand this and advise what I will need. I understand for the pipes that lead outside as its simple, but its more about the bendy stuff that has me confused. I have attached some photos. I should have taken a photo when the U-Bend was attached and then the other pipe that leads to the waste pipe but i forgot. I will taken individual photos of them. I confused on which fitting to use where.
I have been having quite a lot of blockage issues with the sink waste pipe and so decided to take the waste pipe to the drain outside. So i got my DIY hat on and purchased a core drill to make the whole in the wall to feed the waste pipe out. It was a learning curve but finally managed to get it done.
Then I had to figure out how to add to the sink/waste pipe in order to add an additional pipe to feed the waste pipe outside. The setup at the moment is this;
Two sinks => connects to U-Bend => connects to waste pipe which goes around the kitchen and out of the main waste pipe.
I wanted the existing waste pipe to still have a connection as the washing machine and dish washer is connected to it and thought if it ever gets block on the normal one, it can still come out from the "new" waste pipe.
OK cut the story short, I am totally confused on which connection to use. I bought the Push Fit Tee but it doesnt seem to connect to the existing pipes. Can someone please help me to understand this and advise what I will need. I understand for the pipes that lead outside as its simple, but its more about the bendy stuff that has me confused. I have attached some photos. I should have taken a photo when the U-Bend was attached and then the other pipe that leads to the waste pipe but i forgot. I will taken individual photos of them. I confused on which fitting to use where.