Hello. Looking for a little guidance.
Basically had a plumber install new ch system and radiators. He ran pvc pipes (2 22mm, 2 15mm and 1 copper gas main) with angle bends under the concrete floor. We’re now replacing the floor as it has no dpm or insulation and have found none of the pipes were wrapped or put in conduit with two angles just cemented in place. I’ve looked into conduit but cant seem to find anything to apply without disconnecting the pipes. My thought was to use some wood (wrapped in dpm) and create my own boxed in channel. This would give me access from the suspended floor in the room opposite to pull the pipes out if needed. My other thought was to use some sort of plastic square drain pipe turned over and placed on top then cemented over but getting a good fit seems difficult as the plastic is harder to find in different depths. Any help is greatly appreciated.
Thanks
Basically had a plumber install new ch system and radiators. He ran pvc pipes (2 22mm, 2 15mm and 1 copper gas main) with angle bends under the concrete floor. We’re now replacing the floor as it has no dpm or insulation and have found none of the pipes were wrapped or put in conduit with two angles just cemented in place. I’ve looked into conduit but cant seem to find anything to apply without disconnecting the pipes. My thought was to use some wood (wrapped in dpm) and create my own boxed in channel. This would give me access from the suspended floor in the room opposite to pull the pipes out if needed. My other thought was to use some sort of plastic square drain pipe turned over and placed on top then cemented over but getting a good fit seems difficult as the plastic is harder to find in different depths. Any help is greatly appreciated.
Thanks