As per the attached pic, Im planning to run two radiator pipes inside a chase that ivew made in a partition wall so that the pipe work will all be hidden once ive finished the bathroom.
The old pipe work is 10mm microbore with 15mm adapters and a short section of 15mm where the pipes came out from the old paneling.
i was going to cut the old pipe work somewhere on the straight section along the back wall somewhere before the bend and solder in the new pipe work
Would you guys join in a new section of 10mm that could be easily bent/shaped to fit into the chase and solder on short section of 15mm near the end that will fit the rad?
or would you just cut and join in 15mm pipe all the way?
just after some opinions of the best approach for this one
Cheers
The old pipe work is 10mm microbore with 15mm adapters and a short section of 15mm where the pipes came out from the old paneling.
i was going to cut the old pipe work somewhere on the straight section along the back wall somewhere before the bend and solder in the new pipe work
Would you guys join in a new section of 10mm that could be easily bent/shaped to fit into the chase and solder on short section of 15mm near the end that will fit the rad?
or would you just cut and join in 15mm pipe all the way?
just after some opinions of the best approach for this one
Cheers