Any tips on sealing this type of bath waste in the picture. Looking at sealant between every washer and surface. Through I know this can cause the rubbers to slip. Usually come across the bath wastes where you just tighten with a screw. Thanks for any further tips.
Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Discuss Bath waste in the Plumbing Jobs | The Job-board area at Plumbers Forums
- Messages
- 1,235
Good quality clear silly con and not too tight usually works for moi centralheatking
Thanks between every washer and face?
- Messages
- 1,235
yes ...thats how I apply it chking
- Messages
- 6,156
Add some ptfe tape to the threaded section from the overflow slots to 25 mm from the end of waste a smear of quality sanitary silicone on the washers assemble as shown and don't overtighten hand tight and half a turn should be enough . Kop
- Messages
- 6,156
About 8 I would say trail and error really it helps stop the water running down the threads when overflow water enters the waste this is often a problem on vanity unit basin wastes and combined bath waste and overflows only yesterday I attended this one . Kop
Attachments
Last edited:
Similar plumbing topics
- Question
Plumbers mate will do the job better. it's a...
- macka09
- Bathroom Advice
- 3
- 777
- Latest:
- iamajc
10 o’clock / 45 degrees would be better than...
- Question
As it's rented you'd be better off contacting...
- tom1817
- Bathroom Advice
- 1
- 789
- Latest:
- snowhead
- Question
Those Vado wastes are great and it looks like...
- Serval
- UK Plumbers Forums
- 7
- 1K
- Latest:
- fowlerboi