Hi,
I bought a Grohe kitchen tap to replace my existing one and have found that it comes with fixed flexi hoses that are 3/8" instead of the UK standard 15mm fitting.
I saw on an older thread that someone with a similar problem bought a tap tail adaptor from Screwfix with a compression nut and olive so I tried that, however have found the fitting under my sink has a plastic ring with a spring behind it installed (see attached pictures). I tried pulling it out and fitting the adaptor but no luck so far.
Was wondering if someone could take a look and advise on how best to proceed
Thanks,
I bought a Grohe kitchen tap to replace my existing one and have found that it comes with fixed flexi hoses that are 3/8" instead of the UK standard 15mm fitting.
I saw on an older thread that someone with a similar problem bought a tap tail adaptor from Screwfix with a compression nut and olive so I tried that, however have found the fitting under my sink has a plastic ring with a spring behind it installed (see attached pictures). I tried pulling it out and fitting the adaptor but no luck so far.
Was wondering if someone could take a look and advise on how best to proceed
Thanks,