Tape for pipe insulation | General DIY Plumbing Forum | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Tape for pipe insulation

Post thread
Post reply

Discuss Tape for pipe insulation in the General DIY Plumbing Forum area at Plumbers Forums

siricosm

siricosm

Messages
193
Does anyone have recommendations for tape to seal the seams in foam pipe insulation? Most tape seems to get brittle over time and lose its stickiness and lets go.

Also does anyone know of a foam pipe wrap? There are a lot of spots around pipe clamps, valves, pumps, etc. that cannot be covered. All I can find online is something that looks like bubblewrap with foil on both sides. It works great, but it is very flammable (found that out soldering one day). Some kind of wrap like that but made with a fire retardant foam would probably work great. Any other suggestions?
 
Sort by date Sort by votes
Arma flex make sheet insulation and foam tape
 
Upvote 0 Downvote
To seal seams in foam pipe insulation, try using foil tape or heavy-duty duct tape for better strength. You can also use special insulation tape or PVC electrical tape for moisture protection.

For foam pipe wraps, look for fire-resistant foam wrap or fiberglass insulation for high heat. Mineral wool is another safe choice, and self-adhesive fire-resistant tape can help cover gaps. Always check the product labels to ensure they meet your safety and insulation needs.
 
Upvote 0 Downvote
Check the manufacturer's specification sheet for the insulation. This will specify the correct tape to use for sealing joints and also the applications it can be used for. For example, insulation for hot pipes is not the same as insulation for cold pipes. Different types are needed for indoor / outdoor / underground duty. And you've already discovered that they differ in fire retardancy.
 
Upvote 0 Downvote
I was using generic closed cell foam insulation from Screwfix, the grey stuff with a slit in it 13mm thick. I don't have room in a lot of places for much thicker. All the duct tape I have seen dries out after a few years and falls off, I can't imagine that people can actually use it to seal ducts. I'll try the arma-flex foam. Reviews say it is super sticky, and good for insulating around valves and clamps, so maybe can do both.

FWIW, the foil I tried fall off very quickly anywhere there was any tension on it, but it seemed to stay on in areas where it did stick. But that was only after a couple of years.
 
Upvote 0 Downvote
Upvote 0 Downvote

Similar plumbing topics

D
  • Question
Soldering poorly fitting joint - pipe not round, good fill, how?
Just use a compression elbow, we wont tell.
Replies
14
Views
2K
gmartine
gmartine
alex567
  • Question
heat pump and water cylinder installed away from the house, pros/cons
Tbh it’s a must for horizontal cylinders as...
Replies
10
Views
2K
ShaunCorbs
ShaunCorbs
J
  • Question
Why do I hear a hammer related noise coming from my water pipes?
This issue arose about a year ago. Does anyone...
Replies
0
Views
728
Jackson710
J
G
  • Question
Radiator Not Working Consistently
It will get as hot as the system is the valve...
Replies
5
Views
1K
Gasmk1
Gasmk1
I
  • Question
Outdoor water pipe around house
My advice would be to put the drain off...
Replies
3
Views
2K
Ben-gee
B
Back
Top