Search results

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Search results

  1. D

    maintenance access to flush valve

    hello, does anyone look after one of the above for a regular customer? The bathroom fitter has jammed the cistern so close to the underside of the vanity worktop in this ensuite that I can't even look in let alone unscrew the valve from the bayonet. Did anyone get away with cutting an access...
  2. D

    new Sanislim wont pump

    Evening to the Forum. Help appreciated with the above. Fitted new macerator to existing cloakroom wc & macerator set-up I installed about ten years ago. No working noises from motor, water level rises to top of bowl. Confirmed live feed into FCU and out to macerator. Bit baffled with what's not...
  3. D

    dead cheap CWST drain down bung

    My white plastic bung was too big (15mm). Looked in the van , found unused silicone nozzle. The blanked off nozzle type , tapering out, with collar around base. Fitted the tank connector hole a treat. Wont go soggy like the carrot.
  4. D

    new kitchen monobloc empties after closing down lever

    hello, went back the day after, the tap lets out three fl oz( apologies for using old money) after use. Customer didn't like it as he has a water meter. Would an aerator stop this ? Appreciate any suggestions.Dean.
  5. D

    mixer gaskets

    Have any members found rubber long gaskets to replace the white foam ones thatnew kitchen and bathroom mixers come supplied with. Thanks, Dean.
  6. D

    draught through wc overflow

    evening to the Forum. I put a rubber glove over the pipe. held by jubilee clip, and cut tip off one finger. It lasts a couple of months and the customer gets a warmer bathroom. Any ideas for a longer lasting solution apart from fitting internal overflow style flush valve. Thanks, Dean.
  7. D

    access to boxed in low level wc to change ball valve

    hello to forum. Advice appreciated.Hole in front panel for handle spindle.Plastic cistern has enough give, to pull forward the panel to see rusted nut and bolt on other end of spindle & two inches of room between cistern lid and underside of bath worktop. I cant see any screws that...
  8. D

    combi fed H.W. tap drain down problem

    Hello, my first post.Changing a kitchen hot tap washer, couldn't stop the flow after closing combi mains valve.Could there be a large loop going around the loft I hadn't accounted for? Water continued flowing for several minutes without ceasing from all downstairs H.W. taps. Advice appreciated...
Back
Top