Search results

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Search results

  1. phil hair

    ecotec pro 24 blackscreen

    ecotec pro 24, the display screen goes blank after about 10-15 seconds and boiler is completely dead. isolate it for a couple of mins and it comes back on and repeats. dont do much on these, so is it the board, or will a dodgy component do this to the board? Im thinking the fan, so pump runs...
  2. phil hair

    baxi solo 15he ignition lockout

    hi, been to a baxi solo 15 he with ignition lockout fault. seems to run though the ignition cycle, can hear the gas valve open but not sparke. It fired briefly when i disconnected the earth from condensate, but went out immediately. condensates dry, changed the sparker because of continuity...
  3. phil hair

    glow worm ultracom 18hxi low flame problem

    hi, Im looking at a glow worm ultracom 18hxi that heats up to mid 70s/80s works for about 20 mins, then goes into low gas mode (one flame on display) and stays there for the rest of time. no heat in the water or rads. I have changed a 3 way valve (which was jammed with the black stuff) I then...
  4. phil hair

    gat whirlpool bath taps

    anybody know were i can get replacement filler valve for a GAT duvalli whirlpool type bath. tried google, not much showing. thanks
  5. phil hair

    best boiler to replace ideal icos 15

    sorry to ask the same old questions again. Im due to replace an icos 15 he and im looking for your valued opinion. I fit a lot of logic plus combi's , but the heat only requires a wire to the pump from boiler (for the pump over run) I think i read somewhere that this is not required anymore...
  6. phil hair

    main combi 30 eco diverter valve

    hi, i have a main combi 30 eco that has heating but no hot water. I changed the diverter cartridge but that did not fix it. the hall sensor is on, the diverter motor is working, the preheat is working , and although the 'tap' led is lit up, the fan doesn't start, no ignition,ect. should i have...
  7. phil hair

    baxi 105he diverter valve

    hi, ive got a baxi 105 he that's heating the rads when calling for hot water, but no hot water. i changed both the diaphragms on the diverter valve, didn't fix it. I see that both 'pins' operate the micro switches. any ideas? thanks
  8. phil hair

    ideal isar HF error...

    a customer replaced a couple of valves on his heating system,(under cooker heater) and when he refilled, was greeted with the HF error. I thought he had probably air locked it, so bled the pump, and it fired up, but only managed LF. then after a couple of resets went back to HF. Sometimes the...
  9. phil hair

    potterton powermax he a27 fault

    got called to a potterton powermax he a27 fault.(dry fire) phoned technical, said was a circulation problem. the pump was turning, water coming out of the bleed valve above burner, could it be the diverter valve is jammed? thanks...........phil
  10. phil hair

    leaking HX manifold main 24 he

    hi, i have a main 24 he with a heat X manifold that has had small leak on it for a while, the inside of the box was all furred up. ive cleaned it up and replaced the manifold, but for the life of me, i can not get it to seal. What can i use to make it seal? something like plumbers mait? would...
  11. phil hair

    vaillant ecotec pro 28 diverter valve

    hi, does anybody know if i have to replace the whole cartridge or just change the o'rings on the original cartridge for the vaillant ecotec pro 28. if i can get away with the o'rings do you know what size they are? many thanks............phil
  12. phil hair

    best electric shower.

    hi, after last nights news that my showers goosed, what do you guys think are the better 8.5kw showers. had a cheep triton shower,but only lasted 2 1/2 -3 years. thanks
  13. phil hair

    shower smells of fish

    i have noticed recently a faint fishy smell coming from bath while i am showering. (**********ok enough of that fellers****************) its an electric shower, used everyday, so doubt it stagnant water, any ideas?
  14. phil hair

    potterton performa 24 eco he flaim failure

    i have been trying to fix a performa 24 eco he, flame failure fault. (before you ask, yes i am, 546451) originally there was no spark, replaced the spark generator/wire and it was up and running, bobs you uncle, on my way, thank you very much. 2 hours later the lady phones me, its not...
Back
Top