Search results

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Search results

  1. Stoney Ground

    WB 18ri fan running when no call for heat

    Got above where when heating switches off boiler is getting a feed from somewhere, causing clicking noise as it tries to go through start sequence. Where would it get it from, through cylinder Stat or 3 port. Going there tomorrow to check it out but wanted to grab a replacement just in case.
  2. Stoney Ground

    Grohe Movario trio digital shower

    I have a Customer who has 2 of these, installed 2006& 2009 Both are running for 10-20 seconds, then go to 20-service. Have cleaned filters on all inlets and also removed flow restrictor in handset. Was unable to access service mode on controller. Any experts on these have any tips or it’s 2 new...
  3. Stoney Ground

    Looking for ASHP install commission

    I am doing a job in Sussex, and will be installing an ASHP, looking for someone to do refrigerant side of system. Don
  4. Stoney Ground

    Baxi solo 3 PFL 60

    Had one today with terminal with a fin broken, was there a retrofit for this to repair rather than replace flue. cant find part or part number anywhere.
  5. Stoney Ground

    Potterton Promax FSB 30HE

    Went to one of these this week boiler locked out. Reset, and fired then dropped out 5 times to lockout. Checked ignition sensing probes and cleaned, then all 3 cables slid out of porcelain. Combustion door seal was brittle on bottom right. Ordered spares and fitted replaced seals, fired up...
  6. Stoney Ground

    Alpha HE 25

    Changing diverter valve tomorrow after trying to rebuild it with the valve kit, as access was impossible. Have made client remove all boxing by right hand side which even stopped me getting the case off, any hints or tips that make this as easy as possible.
  7. Stoney Ground

    Hot water tap removal

    I am removing a hot water tap as customer does not use and wants the space back under the sink. Any ideas on covering the hole it will leave in the work top. not sure are they standard one tap hole diameter.
Back
Top