Search results

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Search results

  1. robj20

    Ideal Vogue "Flow/Return Thermistor Fault" again.

    Boiler, Ideal Vogue Gen2 C32 Honeywell Evohome with Opentherm. Had Ideal out last year and they changed the thermistor, but this year its doing it again. Strangely same time of year. Suggestions last year from the installer was to remove the Evohome TRV from one radiator to act as a bypass. I...
  2. robj20

    Evohome and boiler issues

    So 3 times now i have had this issue with my boiler turning the burner off because it senses an error on the flow/return temp sensor. Had ideal round to check it out, no faults found they changed the sensor anyway and left me a spare then monitored the system for a while and noted that...
  3. robj20

    One radiator always needs bleeding.

    The vertical hall radiator always requires bleeding at least once a week. At first i thought it was just the system getting rid of all the air, it may still be but it seems like a lot and its always just this one radiator. I have needed to top the boiler pressure back up a couple of times, its...
  4. robj20

    Combi Boiler Electricity usage

    Since having the combi fitted my electricity usage has shot up. Gone from an average of 163kwh a month to 340. So even though gas usage is down a lot, electric going up means its costing us more. Excuse my rough maths but i have the boiler on for approximately 52 hours a week, so if it was...
    • robj20
    • Thread
    • boiler combi combi boiler
    • Replies: 28
    • Forum: Boilers
  5. robj20

    Hydraulic system test

    How long is it wise to leave a system before filling it up, after you have wet tested it as obviously it will stay wet throughout with untreated water?
  6. robj20

    New boiler quotes, what's the going rate?

    Had the first quote back for the following. Ideal Vogue C32 gen2. Vertical flue kit + flat roof seal. Ideal filter. Honeywell Evohome for 7 radiators. Evohome Opentherm Bridge. Re-pipe gas in 22mm, approx 5 meters. Route cold in 22mm, approx 4 meters + stopcock. Remove old boiler...
    • robj20
    • Thread
    • boiler new boiler
    • Replies: 61
    • Forum: Boilers
  7. robj20

    Hep2o in plastic conduit

    I want to bury some 25mm plastic conduit in the wall to allow me to run the flow and return between the downstairs and upstairs, obviously it would mean the pipe is unsupported through the length about 2m. It will be supported top and bottom. Would this be okay.
  8. robj20

    Fitting central heating.

    I'm currently fitting my own central heating with a view for a local company to fit the boiler. Its a vented system at the minute but i want a combi. The boiler will be fitted in the garage to the side wall of the house, my plan is to just run the pipework so the flow and return are on the...
  9. robj20

    Solvent weld pipe into compression stand pipe fitting

    Getting a Mcalpine washing machine standpipe, it has a compression fitting. Will solvent weld pipe fit in this, i hear that some pipes are larger than others. Floplast pipe if that makes any difference.
  10. robj20

    Potterton EP3001

    Have a Potterton EP3001 that after turning the power off has stopped controlling the boiler, to get any heating we have to turn the frost stat on to fire the boiler up. Only the button on the HW side works but it switches the CH on the CH buttons now do nothing. I have tried turning power off...
Back
Top