Search results

Looks as though its a back to the wall pan, suggest you draw around the pan onto the wall to see how much you can cut away after removing the pan for access.

If it is a hole in the cistern than drill out to size of a SS nut and bolt and rubber washer on both sides will cure it.

Plus one on the bypass screw, but I can't think that Riello would not have mentioned to check that?

Visqueed is a good shout, if you have a building site nearby ask if you can skip dive for an off cut, used as DPM under concrete floor slabs.

Interesting read though, only one person asked how much pressure the OP had at the Kitchen sink, answer was high, but most then still told the OP that the problem with low pressure upstairs was probably the stopcock and it needed changing?

Have I got this right, for the Quooker tap to do all it's supposed too it needs a boiler, CO2 cylinder and a refrigeration unit installed and obviously a power supply all in the cabinet under the sink?

Most mixer spray taps are designed for mains pressure hot feed, you may find a pressure/flow booster is required for the tap of choice, look for one with slip joints to enable easy fitting without taking your hot water system apart.

As title anyone using one, good? bad? ugly? has to feed through a de-aireator to the boiler, but should not be a problem, my question is, should the oil line be insulated up the side of the tank, if so how do you attach the insulation to a plastic tank? Pipe being used is green PVC covered...

My CH pump seems to be making more noise than ever before, it's not noisy as such and can only be heard when in the Bathroom, when in the Boiler House the noise is minimal, the thing is it's over thirty years old and possibly coming to the end of its life cycle, I recently changed the HW Zone...

Do you guys find there is a definitive life for Zone valves, there is for the synchronous motors, but what about the movable valve?

Any one have any experience at the cheaper end of the market, can't seem to find one below £100.00, would be nice to have a total flow over a period and current consumption, or am I asking too much?

Guys Modification of any fuel burning appliance is strictly forbidden unless you have the approval from the original manufacturer If you want more efficient boiler change it don’t start modifying your existing one

I can find lots of the above for Boiler installation, but assume for potable water they would be different internally (lined) due to possible cross contamination to the drinking water, anyone know where I can find one?

Anyone been able to download the above, I can't seem to find it.

Fed up with my smoke pump being in a cardboard box, I just bought a pelican case at least it will all stay together and be protected/dry.

I have just been looking at the back page of the Regin service forms, under item 2.4 it says "Change wheel type fire valve for remote acting type" is this a requirement that has been sneaked in and passed me by?

Where is the best/cheapest place to buy replacement sensors for a Testo 327-1 FGA.