Any help greatly appreciated.
It appears that every time i flush the toilet the cistern fills up then overflows back in to the toilet. This can last for 2 minutes or is continually running. I have replaced the cistern dual valve as it was very loose and parts had broken off it and it wasn't a...
Hello everyone. New to the forum and looking for assistance / advice.
I live in a rented house with a not very co-operative landlord. I have just discovered that my bath overflow drain pipe is not connected as the flexible drain tube looks like it has been cut off at some point. After studying...
Hello
We recently had a bathroom referb with a new sink and vanity unit that contained all new plumbing for it. The sink doesn't have an overflow and is draining really really slowly as I understand that there needs to be an air vent in the trap etc.. I know that this is pretty basic but know...
Hello,
I’m new to the business so apologies if this is a stupid question. I was tracing the cistern tank overflow pipe and found it eventually went to nowhere. Basically a disaster waiting to happen. The problem I have is that this is a flat on the 2nd floor with no visible external overflow...
My plumber did not install an overflow when my water softener was fitted, something I found out when it failed and flooded the floor !
I have installed a 12mm overflow hose into a compression T joint, however I'm getting back flow, from both the washing machine, and probably the water-softener...
hi all,
I'm just sorting the drainage for my freestanding bath. Due to a slight misalignment of the drainage / manufacturing error I'm unable to get the rubber seal for the overflow totally compressed up against the bath.
Any recommendations on an alternative to the rubber gasket like Plumbers...
Can this be fixed?
The grill on the overflow on our kitchen sink fell out yesterday. I can feel whatever the grill was connected to when I put my finger in the hole, but can't see how I can get it back into position and screw the grill to it. Any suggestions please??
Hi,
I'm looking to install an unvented cylinder in my property.
I initially hired a plumber who expressed interest in the job, but later cancelled, citing "building regulations" as the reason, specifically regarding the discharge pipe and its location.
Subsequently, I reached out to my second...
I have a ROS small faucet for drinking water. The main faucet in the kitchen works find. I recently replaced the main faucet but after reconnecting everything, the overflow on the ROS drinking water faucet will not stop running. The only thing connected to the ROS that I manipulated was an...
Hi
Overflow suddenly spouting out luke warm water to outside of house, checked on down pipe in photo leads exterior overflow, could put finger spout when overflowing and its luke warm water.
Why is it overflowing? Lot of water coming out.
Photo attached of side of tank to show above.
What is...
Hi Everyone,
I recently brought a replacement Pop Up Waste from Argent K316-DL & the spec states it suits both overflow & non-overflow basins.
However it has no slotted waste opening. How could this be used with sinks with an overflow hole & still prevent sink overflow?
Thanks
Natalie
Argent...
I have an overflow pipe (standard diameter 21.5mm) sticking out through a hole in a white uPVC fascia board at our house, but the overflow pipe is no longer required and could be removed. However, before removing it, I need some way of capping the hole - a white barrel plug, for example. Does...
Hi, I wonder if you could help me. The overflow pipe drips intermittently from the large cold water storage tank in the loft. Not the small F and E tank. The ball valve has been checked and is working ok. The vent pipe from the hot water cylinder is not venting any water into the tank, and the...
Hi,
I'm really struggling to find out what part I need to use deck valves like this
with a overflow bath filler. Most bath fillers seem to only have one connection. This one has 2, one for hot one for cold which looks like it could work.
Anything I'm missing?
thanks
Hi, We have a Grant oil combi boiler. Only 3 years old. Been a right pain. Already had expansion vessel replaced and the 3 bar PRV and another thing that I have forgotten name of, but it has a load of copper mini pipes is a square loop. Then when it was really cold the overflow started chucking...
Hello, as is common with most newbies I've arrived with a problem.
Our water softener is about 18 months old, a BWT WS355 in an insulated outside cabinet.
It's probably the third we've had - been here a very long time and always had a softener.
I installed it myself, just connecting to existing...
Hi all
I purchased a freestanding bath and when I came to cut the holes for the taps I realised the hole for the overflow is misaligned with the drainage (see photo). There's some room within the overflow hole that allows me to straighten the chrome fitting in line with the drainage, but not...
I hope someone might explain to me why the overflow from the expansion tank drips in the morning for about an hour after the heating fires up, it then stops and does not drip again during the day.
I have a fully pumped "Y" system as show on the accompanying drawing the dripping occurs on the...
Hi hopefully someone can advide me on this matter . I got new complete new bathroom refurbished ths next day overflow outside started dripping. As usual company said not there problem to check ballcock which i have by plumber nothing wrong with this . I am really looking for a different answer...
Hi folks. I've noticed recently that water is dripping from my Megaflow overflow pipe outside coinciding with the time the heating turns on to heat the water.
Whilst the water is dripping, the pressure on the Megaflow is reading around 8 bar.
Dripping from overflow stops and the pressure...