15mm to 10mm on CH system | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss 15mm to 10mm on CH system in the Plumbing Jobs | The Job-board area at Plumbers Forums

Messages
21
I currently have a central heating system with 15 mm pipework running up through the floorboards to the radiators.

I would like to convert the 15 mm pipe to 10 mm pipe underneath each radiator and run the 10 mm pipe up the wall behind the radiator. Basically so I don’t see pipework coming up through the floor.

So each radiator will have approximately 1 m of 10 mm pipe running to and from it.

Is this going to cause any problems i.e. flow or pressure issues?

Thanks,

Mark
 
No don’t see it will be / cause any issue
 
There is no problem doing this and if you buy a 10mm mini bender you will be able to get some dandy bands so the whole thing does not look like electricians spagettee ...use some end feed 15mm male to..10mm connectors it will make a nice neat job. But remember autumn is here and depending on your competance you might not be flavour of the month if you overshoot on time with ur Mrs and Kids
good luck centralheatking
 

Similar plumbing topics

  • Question
Doesn’t really answer any of my questions but...
Replies
6
Views
572
You’re 200 miles away - he is there. You’re...
Replies
3
Views
654
T
  • Question
Sounds OK so long as the heating system is...
Replies
2
Views
386
G
Personally at that size UFH I would want a...
Replies
2
Views
811
Thank you for the replies. I had another...
Replies
4
Views
904
Back
Top