22mm Low pressure Check / non return valve, shower pump problem | Showers and Wetrooms Advice | Plumbers Forums
Guest viewing is limited

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss 22mm Low pressure Check / non return valve, shower pump problem in the Showers and Wetrooms Advice area at Plumbers Forums

Jones82

Gas Engineer
Messages
221
Hi

Anyone know where you can get a 22mm low pressure non-return valve, it was suggested by Grundfos to combat the pump turning on when a hot tap is used...

I've already put a U in the pipework coming off the essex boss.

The pipe work is a little strange, it comes off the top of the cylinder, the feed to the hot taps goes up to the loft, vents, runs across the loft 6m then drops down to feed the rest of the house. The shower supply is separate to this, being feed from an essex boss on the cylinder.

I'm thinking of fitting the non-return on the supply to the pump... actually wouldn't it better on the hot supply to the taps?

Thanks
 

Similar plumbing topics

  • Question
Hi SI......is the shower on the same floor as...
Replies
12
Views
364
  • Question
I don't see your comments?
Replies
8
Views
808
S
  • Question
Many thanks, Ben-gee - that's very useful...
Replies
2
Views
828
Steveo111
S
A
  • Question
Stnd wrong pump for a high pressure shower...
Replies
1
Views
728
  • Question
Yup and undersized flow/returns/heat emitters...
Replies
29
Views
6K
Back
Top