Air block on hot tap problem | Air Sourced Heat Pumps | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

  • Thread starter maximus
  • Start date
  • Replies 3
  • Views 967

Discuss Air block on hot tap problem in the Air Sourced Heat Pumps area at Plumbers Forums

Status
Not open for further replies.
M

maximus

Hello all, i have just replaced my toilet and basin/taps in my bathroom upstairs, I have run the system and all other hot feed taps are fine in the house but I cant get a drop out the one ive changed, ive checked all valves and had the mixer tap off and apart. One thing to mention is I previously had the same fault on the water feed in question when I first bought my house, I had a plumber in who re piped a section of it and he said the previous owner had tapped off a vent? He held his finger over the tap and it started to back feed in to the tank? Anyhow when he'd finished all was right, for months, untill now. Any help would be appreciated.
 
Thanks for your reply, sorted it now, tried the finger over tap trick but to no avail. Managed to suck it through by mouth in the end, got rather light headed but all is now as it should be
 
Status
Not open for further replies.

Similar plumbing topics

  • Question
You’re a genius, thank you! Held my thumb over...
Replies
2
Views
999
  • Question
Before doing this, check the level in the cold...
Replies
9
Views
1K
  • Question
Thanks very much for all the advice John, it's...
Replies
13
Views
997
  • Question
It could be best to get him back to have a look
Replies
24
Views
2K
S
  • Question
When you flush the toilet, do you hear any...
Replies
1
Views
435
Back
Top