air lock | Air Sourced Heat Pumps | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

  • Thread starter mark anthony
  • Start date
  • Replies 6
  • Views 3K

Discuss air lock in the Air Sourced Heat Pumps area at Plumbers Forums

Status
Not open for further replies.
M

mark anthony

I have just fitted an extra radiator to my central heating system, after refilling & bleeding all the rads, only the rad in the bathroom gets hot, i have an open vent syster with a vallent 415 boiler with a copper tank back up, i have tride to blead the cerculation pump but nothing happened???????????
 
turn rads of leaving just one open at a time, go round all of them one by one then turn pump off and bleed again, if its just airlocked it will normally push it through.
 
I tride shuting them of & runing one at a time but no joy, only the bathroom one works upstairs & 2 down stairs, the sistem if filling ok from the mini tank in the loft, i have also bled the valve in the loft, i even tride ataching a hose to a rad downstairs & back flushing but this made no diferance.
 
Try bleeding the pump. Have a towel ready and undo the large screw at the front and if an egg cup full (approx) of water comes out then it's bled.
 
That's okay - it can happen that the air lock (if there is one) is around the pump area. If there was an air lock there then no water would have come out!
 
Status
Not open for further replies.

Similar plumbing topics

  • Question
You’re a genius, thank you! Held my thumb over...
Replies
2
Views
999
  • Question
Red circles show my new AAVs and the manual...
Replies
17
Views
2K
  • Question
It could well be, the OP will soon hopefully...
2
Replies
35
Views
3K
  • Question
Not strong enough to pump the water round or a...
Replies
3
Views
1K
  • Question
Before doing this, check the level in the cold...
Replies
9
Views
1K
Back
Top