S
Stevehessex01
Advice sought please...Last week I removed our our bathroom radiator and fitted on to the pipes, a heated towel rail. Made a good job of it felt really pleased!
Had to drain down the radiators, fitted towel rail, then re-filled the system + inhibitor.
Started central heating and bleed radiators but over the last few days has continually made dull rumbling knocking noises seemingly also when the hot waters on
Now woke up this morning no hot water - Suprema 50 flashing red, do a restart and after about two minutes and some noise, trips out red again.
Radiators are all full and do not need bleeding.
So the question is obviously what's happening but also why is the hot water affected when I touched was the central heating - thought there were separate?
Any advice from anyone will be greatly appreciated
Had to drain down the radiators, fitted towel rail, then re-filled the system + inhibitor.
Started central heating and bleed radiators but over the last few days has continually made dull rumbling knocking noises seemingly also when the hot waters on
Now woke up this morning no hot water - Suprema 50 flashing red, do a restart and after about two minutes and some noise, trips out red again.
Radiators are all full and do not need bleeding.
So the question is obviously what's happening but also why is the hot water affected when I touched was the central heating - thought there were separate?
Any advice from anyone will be greatly appreciated