Any clever ideas for cleaning soot blockage from Grant Condensing Heat Exchanger? | Oil and Solid Fuel Forum | Plumbers Forums
Guest viewing is limited

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Any clever ideas for cleaning soot blockage from Grant Condensing Heat Exchanger? in the Oil and Solid Fuel Forum area at Plumbers Forums

Vee

Plumbers Arms member
Plumber
Gas Engineer
Subscribed
Messages
427
Anyone got any suggestion on how, if possible you could clear soot from the condensing heat exchanger of a Grant Vortex. Have many of you encountered blockages like this? Have any of you been able to avoid condemnation of the boiler the due to the stainless heat exchanger being blocked? What can be done? Seems a shame to replace as otherwise in reasonable condition.
 
A lot of the products for cleaning oil heat exchangers are not recommended for condensing boilers .
I take it the spiral turbulators are stuck solid?
 
Just had a chat with my oil service engineer (I subcontract all my boiler servicing) He confirmed its a scrape and vacuum job Grant don't recommend any of the soot breakers .
 
Elbow grease, patience and a dust mask. Followed by a big bill at the end.
The worst part of working on oil is a sooted boiler. Especially when they tell you it's been smoking for 3 or 4 days before it locked out.
 
Classic car enthusiasts often use an ultrasonic bath for de-coking cylinder heads. A couple of minutes treatment and they come out looking like new. Might be worth a try, perhaps?
 
An update. Boiler cleaned and running fine. Could do with some new turbulators and blast tube. Needed setting up properly. The boiler flue had been replaced by someone following vandalism by tenant. Sootbreaker not applied. (Although Grant Technical were a recommending party too). Appears customer was fed some bull from other engineer trying to get a boiler change.
 

Similar plumbing topics

unless you are gas safe reg, you should NOT...
Replies
1
Views
671
    • Like
readings all check out on low rate(had them...
Replies
11
Views
2K
I have done it before with a standard 28mm...
Replies
14
Views
3K
Hi. I've taken a break from all the sites I...
Replies
8
Views
3K
There's nothing wrong with external boilers...
Replies
4
Views
2K
Back
Top