Are these pipes acceptable? | General DIY Plumbing Forum | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Are these pipes acceptable? in the General DIY Plumbing Forum area at Plumbers Forums

Messages
3
We had a leak from our boiler which meant I had to take up the flooring. This was a bathroom, but we want a utility room, so will be putting in the washing machine. I don't know if these pipes are accetable though? We need the water feed (on the left) and the pipe for the waste (you can see on the right curving behind the boiler pipes). The waste pipe is 22mm OD.
This is part of an extension at the front of the house built by a prevous owner, the pipes dissappear under what used to be the external wall.
 

Attachments

  • IMG_20210303_124541.jpg
    IMG_20210303_124541.jpg
    422.6 KB · Views: 68
They look fine would clean all the rubbish out under the floor tho
 
They look fine would clean all the rubbish out under the floor tho

I never really thought about this but can I pick your brain.

If I hadn’t read your post, I would have advised against connecting a washing machine discharge to an overflow pipe.

Wouldn’t the increase in friction of the overflow pipe compared to 1.5 inch waste, cause issues with the washing machine pump?
 
It’s one of them bigger always better but if it’s only a short run it should be fine and it looks like one was connected there before left hand side washing machine point
 
It’s one of them bigger always better but if it’s only a short run it should be fine and it looks like one was connected there before left hand side washing machine point
Well, i'm not sure if it is a short run. I'm not sure where they go once under the wall. The kitchen and bathroom are at the back of the house, as are the drains I believe. Thats 10m back and 5m across.
 
Where does the boiler condense go into ?
 
We had a leak from our boiler which meant I had to take up the flooring. This was a bathroom, but we want a utility room, so will be putting in the washing machine.
I don't like the look of the the way the ends of the joists are being supported. The piece running left to right looks undersized to me and I can't see where the load is being transmitted to. If you put a washing machine there the joists are going to get a regular thumping during the spin cycles.
 

Similar plumbing topics

  • Question
If you go and put your hose in the top like...
Replies
1
Views
353
  • Question
If it's a condense pipe it should be replaced...
Replies
2
Views
225
  • Question
To add to this, ensure the discharge hose...
Replies
2
Views
1K
  • Question
When speedfit came out they one made that type...
Replies
22
Views
1K
  • Question
Bit high for flashing on the window
Replies
3
Views
393
Back
Top