P
paulbaker1954
I need to put new washers on my Bath Taps. Its a shower mixer with a pull/push shower/bath swap and two taps. Take a look at the picture below.
The taps are chrome and for the life of me I cannot see how to get the knobs off to be able to get at the rest. There is no obvious cap that comes off, no allen screws anywhere on the knobs. I have run a sharp knife around the rings on the top and also tried to see if the very top piece (where marked with H and C) will unscrew by tapping at it with a screwdriver.
I have tried pulling hard upwards in case they just pull off and also tried levering with a large screwdriver - all with no joy. I didn't want to welly it harder in case I damage the taps.
Has anyone dealt with anything like one of these or maybe even recognise the make so I can contact the manufacture r
The taps are chrome and for the life of me I cannot see how to get the knobs off to be able to get at the rest. There is no obvious cap that comes off, no allen screws anywhere on the knobs. I have run a sharp knife around the rings on the top and also tried to see if the very top piece (where marked with H and C) will unscrew by tapping at it with a screwdriver.
I have tried pulling hard upwards in case they just pull off and also tried levering with a large screwdriver - all with no joy. I didn't want to welly it harder in case I damage the taps.
Has anyone dealt with anything like one of these or maybe even recognise the make so I can contact the manufacture r