Baxi combi pressure issue | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Baxi combi pressure issue in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

armyash

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
2,650
Looking at a baxi combi tonight. Pressure drops to 0.2 but will go up quite high when running on CH. Needs repressurising regularly.

I don't have a lot of info yet but what could cause this?

I'm going to check prv and ex vessel anything else I should look at?

Thanks
 
Thanks Harvest Fields.

Pressed schraeder valve, no water but no air either. Couldnt recharge because my pump was broken.

Would this cause the same symptoms?
 
Recharged last night, ran it on max until it went up, usual rise on gauge from 1bar. Not heard back, fingers crossed.
 
I use to say that now can' be bothered just tell them get new one.
Must admit to getting a bit the same, because you take the time to repressurise it and it fails to cure it 2/3days later ,then they never expect to pay for one of the visits
 
Status
Not open for further replies.

Similar plumbing topics

P
  • Locked
Doesn't matter, mod will remove or close it.
Replies
3
Views
905
Again, ongoing thanks. I'll have to get to my...
Replies
18
Views
2K
No. It is possible the pressure relief is the...
Replies
6
Views
912
It’s an automatic air vent - you can close it off.
Replies
1
Views
1K
Deleted member 120897
D
Np Simon. Hoping to get the boiler engineer...
Replies
4
Views
964
Back
Top