Been to a boiler this afternoon, Baxi solo, same as a promax?
fixed the initial fault but noticed water in combustion chamber and staining down the outside casing where the manifold bolts throughout the case. It looks like the hex is leaking out of a round recess on the right side of the hex, dripping onto gas pipe from gas valve to fan etc. it's hard to tell as there is only a 5mm gap between this and the combustion chamber side panel.
Is this a common fault, and will it require a complete hex replacement if so? If anyone has done this is it feasible or is the boiler a write off?
cheers in advance
fixed the initial fault but noticed water in combustion chamber and staining down the outside casing where the manifold bolts throughout the case. It looks like the hex is leaking out of a round recess on the right side of the hex, dripping onto gas pipe from gas valve to fan etc. it's hard to tell as there is only a 5mm gap between this and the combustion chamber side panel.
Is this a common fault, and will it require a complete hex replacement if so? If anyone has done this is it feasible or is the boiler a write off?
cheers in advance
Last edited: