Blocked outdoor tap | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Blocked outdoor tap in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

kasser

Gas Engineer
Messages
237
I opened the isolation valve to my outdoor tap today after several weeks but no water came out of it. I opened it to see the hole blocked with some sort of white plastic disc. I pushed it opened and fitted back the tap and all was fine.

Is this white plastic bit part of the non-return valve? Did it get stuck in this closed position? Is there a way to release it without undoing the tap?

There is a small nut at the bottom of the tap. What is its use? It barely protrudes so I'm not even sure I could grasp it with a spanner.

tap.jpg
 
Yes very common and with the cold weather they stick best to replace the out side tap like for like

Outside Tap with Double Check Valve 15mm x ½
 
Its only stuck bud replace it if you wish but its not serviceable really . cheers kop
 
Best to replace with a non check valve tap and fit a double check valve inside.
 
Status
Not open for further replies.

Similar plumbing topics

  • Question
Thanks Knappers. Yes, good point - definitely...
Replies
2
Views
1K
  • Question
I haven’t used my socket set yet. Purely...
Replies
4
Views
1K
  • Question
This issue arose about a year ago. Does anyone...
Replies
0
Views
725
  • Question
Also I don't think he'll be able to get a bit...
Replies
12
Views
2K
  • Question
Could an unvented cylinder without check valve...
Replies
18
Views
3K
Back
Top