D
Deleted member 98304
Hello all
I have just replaced and relocated a hot water tank and immersion heater. The two were previously connected with 14mm copper and a tap on just near the outlet of each. Obviously the taps used to be opened and closed to take hot water from either the tank or the boiler.
My intention is to have hot water come from the boiler when it is fired up and in use (it supplies the CH) which will be mostly in the winter and from the immersion in the summer. Perhaps there's some way of having the boiler fill up the tank when it's in use.
Can I achieve this with some electronic valves and a controller?
I have yet to buy a controller for the central heating.
There is a 20mm PER pipe between the two with the kitchen hot water T'd off near the boiler and the bathroom hot water T'd off near the immersion.
Thanks in advance.
I have just replaced and relocated a hot water tank and immersion heater. The two were previously connected with 14mm copper and a tap on just near the outlet of each. Obviously the taps used to be opened and closed to take hot water from either the tank or the boiler.
My intention is to have hot water come from the boiler when it is fired up and in use (it supplies the CH) which will be mostly in the winter and from the immersion in the summer. Perhaps there's some way of having the boiler fill up the tank when it's in use.
Can I achieve this with some electronic valves and a controller?
I have yet to buy a controller for the central heating.
There is a 20mm PER pipe between the two with the kitchen hot water T'd off near the boiler and the bathroom hot water T'd off near the immersion.
Thanks in advance.