B
boulter
It's a Boulter Camray 5 oil burning combi.
When heating is on shower and bath are piping hot.
When you shower during the day when no heating on it runs cold after a minute.
The pipes to the DHW storage tank feel hot but it's as if this tank isn't full before showering so runs cold quickly.
Where does this tank get a signal from to keep hot during the day?
Is the tank stat just for the cutout temp or cut in as well?
Tank stat works ok when heating is on as tank is hot and full then.
Presume flow switch is ok as DHW is supplied when shower is turned on(when heating on)
Think 3 way valve is ok for the same reason and heating is fine.
The programmer is a sunvic TLX rfp with a remote programmable room thermostat.
The 15mm water supply pipe to storage tank ,before flow switch, is half open, should this be full open?
Thanks for any help
When heating is on shower and bath are piping hot.
When you shower during the day when no heating on it runs cold after a minute.
The pipes to the DHW storage tank feel hot but it's as if this tank isn't full before showering so runs cold quickly.
Where does this tank get a signal from to keep hot during the day?
Is the tank stat just for the cutout temp or cut in as well?
Tank stat works ok when heating is on as tank is hot and full then.
Presume flow switch is ok as DHW is supplied when shower is turned on(when heating on)
Think 3 way valve is ok for the same reason and heating is fine.
The programmer is a sunvic TLX rfp with a remote programmable room thermostat.
The 15mm water supply pipe to storage tank ,before flow switch, is half open, should this be full open?
Thanks for any help