broken boiler - who do I trust?!

[FreezingHackney]

It's finally happened - my boiler just stopped working last night. I bled the radiators, topped up the water/loop thing - things that have worked in the past but they had no effect this time. The LED display has the 'Air pressure switch should be checked' light flashing.

I hope you don't think I'm whining too much but I really feel that this is where my nightmare begins: historically, I have had the worst luck with getting plumbers and the like. I'm prepared to pay for a job well done - but feel (woman on her own and all that) I've just had the mickey taken out of me.

And so to the internet: the BBC has something saying I need to get someone registered with CIPHE. I called all 10 of those listed for my area - one came out today to look, a further 2 said they could come next week. Nothing from the rest.

The guy who came out seemed like a straight up and down guy - but how do you tell?! He's quoted me around £280 to replace PCB (this without VAT). What do you think? Not even sure that the PCB is the problem - how would I ever know? I know it's one of the costliest parts to replace.

I've been swayed away from getting British Gas to come out, inspite of reasonable sounding quotes, after reading the stuff on this forum about the watchdog programme.

Guilty - yes - I haven't had the boiler serviced in the last few years - because of same problem - who can you really trust?

I'd really appreciate any (constructively critical) advice - please be kind! I know there must be reputable and honest and hardworking engineers/plumbers out there - I just seem to have a bother of a time finding one!!

Thanks in advance for your words of wisdom or kindness, Freezing (and, frankly, a bit grubby now) in Hackney.

 

[Whn1]

You've walked into a land of reputable honest hardworking plumbers!

 

[SafeGasInstall]

I am working tomorrow mornig in Hackney , if you need help pls see my web address below .

Stan

 

[Whn1]

And who can you trust? That's for you to decide on first impressions or recommendations.

 

[SimonJohns]

Why don't you post on here. Try and get one of the trusted advisers or a long time poster and you'll be sure of an excellent service

 

[SimonG]

Firstly welcome to the forum

It's always a tough call and somwthing I hear quite a bit from people who have never had plumbing or heating problems, people new to the area and people who have seen all the 'rogue' trader programmes. They want a good honest bloke to do a job and are prepared to pay the going rate for a good job.
If you can't get a recommendation from a friend, relative or coleague then you have come to the right place. Safegasinstall has expressed an interest in being available and is a top bloke.

Hope you can get sorted.

 

[mountainman]

Good luck with your repair.
You would be well advised to use one of the cynical sods off this forum for your job.
Most are top notch and have no desire to rip you off. IMHO

 

[jase158]

May I just add, bit obvious to us, but they must be Gas Safe registered. Ciphe is nothing really, most reputable plumbers don't need it as it costs a lot, takes up a lot of time and any good plumber will be busy enough without it.

Few tips in my opinion,

ask if they are time served or not. any time served plumber has done at least 5 years shadowing a plumber, has worked hard to get where they are and is keen to keep their reputation up

A none time served plumber has done the course in a few months and may not care about his workmanship.

Ask for references and check them, when i looked for a tiler, one guy gave me references and when i rung them the customer was not happy, had to keep calling him back and was met with disgruntled tiler when he complained.

Check previous work, if i was happy with somebody's work I would let other people come and see it.

Spend time getting it right. you need this person quite often and a good relationship is key.

But remember, we all get it wrong, sometimes we might think it is a PCB, but it is actually a sensor. some jobs are not as simple as they seem. Hardest part of our job is when customer says, what is it? and expect an exact explanation, but it aint always that simple. there is no boiler diagnosis tool. although some boilers are better at telling you what is wrong then others.

It is not what we can do, but how we explain the problem that makes the difference.

 

[desrob]

May I just add, bit obvious to us, but they must be Gas Safe registered. Ciphe is nothing really, most reputable plumbers don't need it as it costs a lot, takes up a lot of time and any good plumber will be busy enough without it.

Few tips in my opinion,

ask if they are time served or not. any time served plumber has done at least 5 years shadowing a plumber, has worked hard to get where they are and is keen to keep their reputation up

A none time served plumber has done the course in a few months and may not care about his workmanship.

Ask for references and check them, when i looked for a tiler, one guy gave me references and when i rung them the customer was not happy, had to keep calling him back and was met with disgruntled tiler when he complained.

Check previous work, if i was happy with somebody's work I would let other people come and see it.

Spend time getting it right. you need this person quite often and a good relationship is key.

But remember, we all get it wrong, sometimes we might think it is a PCB, but it is actually a sensor. some jobs are not as simple as they seem. Hardest part of our job is when customer says, what is it? and expect an exact explanation, but it aint always that simple. there is no boiler diagnosis tool. although some boilers are better at telling you what is wrong then others.

It is not what we can do, but how we explain the problem that makes the difference.

wow...you have come on leaps and bounds

 

[Mike Jackson]

May I just add, bit obvious to us, but they must be Gas Safe registered. Ciphe is nothing really, most reputable plumbers don't need it as it costs a lot, takes up a lot of time and any good plumber will be busy enough without it.

Their speaks someone who knows nothing about the CIPHE. I've been a member for over twenty years, not for what I get out of it but for what I can put back into it. Membership of a voluntary organisation shows a commitment to professionalism over and above the compulsory membership of Gas safe etc. CIPHE membership is only available to suitably qualified professionals who all abide by a strict code of practice.

 

[jase158]

Their speaks someone who knows nothing about the CIPHE. I've been a member for over twenty years, not for what I get out of it but for what I can put back into it. Membership of a voluntary organisation shows a commitment to professionalism over and above the compulsory membership of Gas safe etc. CIPHE membership is only available to suitably qualified professionals who all abide by a strict code of practice.

Apologies if I have offended, Just my opinion and those of plumbers I know and spoke to. different areas, different opinions.

 

[mountainman]

Since when has a Time Served Plumber been equivalent to a GSR heating engineer.

 

[desrob]

Since when has a Time Served Plumber been equivalent to a GSR heating engineer.

the point being you have to be time served to be a member ciphe, and un like gas safe it is not compulsary, making it my opinion

 

[mountainman]

Oops, just read the other posts.
I joined CORGI when it was voluntary and before it became a money earner.
I've never heard of cipse or whoever they are and I've been a professional and business owner for 40 years.
If they eluded my radar then they were'nt worth knowing!

 

[Puddle]

What make and model boiler is it ?

 

[mountainman]

Seems that the OP has gone AWOL.

 

[Hardy1]

get a Gas Safe Registered Engineer out please check he/she is registered ID card and if your still not sure ring gas safe or check their details online..and good luck my friend there are plenty of good plumbers around and yes there are also bad ones..just make sure you get the right 1.

 

[jase158]

the point being you have to be time served to be a member ciphe, and un like gas safe it is not compulsary, making it my opinion

requirements to be on CIPHE = Qualification and relevant experience

If no experience is provided (reference) then site visit.

So Jo went to a training centre, gained his Gas safe, NVQ's and all qualifications in 6 months, he doesnt care about his job as he has just changed from mcdonalds to become a plumber. He gets his mate to give him a reference saying he has worked for 2 years in the plumbing industry, He is Ciphe registered.

Bob has been plumbing for 40 years and he has no qualifications so can not get Ciphe registration.

Who would you trust?

I'm not saying all Ciphe members are from training centres and don't care about their job, but in my opinion it isnt worth nothing. I could easily pass my driving test but put me on my own and I would fail every time.

It's not easy to get 40 years of driving experience.

Who would you trust?

However don't CIPHE offer a guarantee i.e. so to protect the customer? can't remember now.

 

[SafeGasInstall]

keep it to the topic of the thread lads ,

that is why you see Puddles post there !!!

 

[jase158]

No????

if the member is found to be doing wrong, they get kicked off, wow that is harsh.
They have a barrister, a trading standards officer and technical investigators and they cant even promise they will investigate and prosecute any plumber who is doing wrong.

Further more they state, "we can only accept complaints about members of the CIPHE, as the Investigation/Disciplinary Committees have no jurisdiction over non-members"

Meaning that I am only liable to investigation or grief if I pay them money.

If they were prosecuting cowboys, I would be more keen to be a member, but they only investigate if I pay them money, not a chance

 

[Mike Jackson]

How do you propose a voluntary organisation takes action against non members? In the example above Bob would be eligible to join as plumbers with extensive practical experience but no formal qualifications may be eligible to join.

The CIPHE has been campaigning for compulsory registration of plumbers for a very long time but with little success as the politicians and general public don't realise the dangers involved in plumbing and heating other than gas works.

 

[mountainman]

Sure ciphe or whoever are campaigning for compulsory registration of plumbers. Would I be cynical if I wondered if there was a financial motive to their enthusiasm.

 

[dancinplumba]

Their speaks someone who knows nothing about the CIPHE. I've been a member for over twenty years, not for what I get out of it but for what I can put back into it. Membership of a voluntary organisation shows a commitment to professionalism over and above the compulsory membership of Gas safe etc. CIPHE membership is only available to suitably qualified professionals who all abide by a strict code of practice.

100% behind you mike

 

[Rickster123]

And you wonder why the op has done a runner! Have a beer chaps!

 

[tamz]

.
I've never heard of cipse or whoever they are and I've been a professional and business owner for 40 years.
If they eluded my radar then they were'nt worth knowing!

Used to be known as the institute of plumbers. They do a lot of worthwhile work for the benefit of all plumbers whether or not they are members.
I am not a member but i am a member of snipef. That is a voluntary organisation too and membership costs me a good bit more than gas safe does but that is my choice.
Personally i think the registration and licensing of all plumbing work should be made compulsory which would hopefully raise standards. This has been lobbied for for many years, even since before corgi came on the scene which would only put us on the same par as other 1st world countries.
A blind man can see how bad some of the work now being done is and there is the never ending tv programs highlighting it to the general public. This is leading to people being scared into the hands of the big companies for fear of what they may get from independents as the thoughts of the OP of this post shows.

To the OP.
Safegas (Stan) will do you a good job for a fair price so may be worth giving him a PM.