Clean air intake - position | Air Sourced Heat Pumps | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Clean air intake - position

Post thread
  • Thread starter Mr K
  • Start date
  • Replies 2
  • Views 656

Discuss Clean air intake - position in the Air Sourced Heat Pumps area at Plumbers Forums

Status
Not open for further replies.
M

Mr K

Where a gas hob is installed in a room with no direct door or window connection to the outside a clean air intake must be provided. This is well documented elsewhere including the cross sectional area, sleeving, etc.

My question is where can that intake be positioned? Is there a minimum height, internally or externally? I'm guessing there might rules so that it cannot be blocked by flooding, drifted snow, frost, etc but so far I cannot find anything documented.
Advice anyone? Ta muchly.
 
Sort by date Sort by votes
Hi there ?Mr K and welcome along to the forum,
If you read technical bulliten 00?

If you are gassafe registered get your post count to 10 and pm a mod to gain access to private gassafe forum for proper advice , if your not gassafe registered then you should get an engineer in to do this right,
 
Upvote 0 Downvote
Status
Not open for further replies.
Back
Top