Have been doing some servicing and safety checks for a HA over the last few weeks, mainly boilers and cookers so all good. Had one yesterday with a gas fire and didn't think anything of it until the system we use asked for a flue analysis and then i realised I've never used a FGA on a gas fire before. Last time I did servicing on a fire they weren't readily used, just had to rely on the usual checks.
It ran up fine as you would expect with all the excess air but just wondering what the permissible figures are, is it 0.02 as stated for BBU with fire or am I completely missing where's it's written as I can't see it listed on the standards anywhere?
Cheers, Sam
It ran up fine as you would expect with all the excess air but just wondering what the permissible figures are, is it 0.02 as stated for BBU with fire or am I completely missing where's it's written as I can't see it listed on the standards anywhere?
Cheers, Sam
Last edited: