Concealed cistern fill valve.

[Matt0029]

Has anyone got an idea what make concealed cistern this maybe? I need a new full valve for it. Thanks

 

[ShaunCorbs]

Just looks like a stnd inlet valve maybe a Thomas Dudley fill valve might fit etc

Edit it’s a cera/ siamp frame

 

[Matt0029]

Just looks like a stnd inlet valve maybe a Thomas Dudley fill valve might fit etc

Edit it’s a cera/ siamp frame

Have you come across these before. It's a siamp frame?

 

[Matt0029]

I should of looked closer does it look like 3/8s or 1/2?

 

[Matt0029]

I was thinking possibly looked like that

 

[ShaunCorbs]

I was thinking possibly looked like that

1/2 and yes

 

[Matt0029]

Thanks so that Torbeck should do it? The Flexi should seal up ok again?

 

[Matt0029]

I should be able to get into it all with spanners through the wall plate like it is? I haven't done much with concealed cisterns before. Thank you

 

[ShaunCorbs]

Yes and yes you can pull it out and tighten the flex on the just nip up the retaining nut

 

[Matt0029]

Thanks. Then setting the height hopefully just set it to the same height as the last one? As probably can't get in to it afterwards.

 

[Matt0029]

Are they usually just a half inch female ended flex? I know the ones on the grohe ones kind of push in to the threaded body.

 

[ShaunCorbs]

1/2 by 3/8 probably

 

[Matt0029]

Thanks but should just be a normal 1/2 female end on this one? Thanks again as said not done much with concealed

 

[ShaunCorbs]

Yes ball valve end should be 1/2

 

[Matt0029]

Thanks what's happening with it is. Flush the toilet. It flushes water stops flowing in to bowl. It then starts flowing in to bowl as the fill valve isn't shutting off. It will stop for some reason if pressure the small button on the flush plate. Strange!

 

[Matt0029]

Isolation on the valve at the top is usually ok?

 

[Matt0029]

Isolation on there. For the cistern

 

[Matt0029]

So anyone know what the blue but is sticking out if the thread? Worried this would effect the Flexi sealing?

 

[ShaunCorbs]

It pushes in further / cut it off it’s a strainer / flow limiter and yes iso valve normally ok

 

[Matt0029]

Any idea why it just fills and won't stop. I presume this is a washer or problem with the arm. But then why it stops when the small flush button is pushed. Unless it's jolting it to shut it off.