Confused with rad pipe connection | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Confused with rad pipe connection in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

kasser

Gas Engineer
Messages
237
I've got a radiator with two dissimilar ends where the pipes are connected. One end is familiar to me, it's 15mm diameter, bit of pipe with olive and nut and the whole thing has been screwed onto the radiator. You just need to screw the TRV or lockshield valve to it.

The other one is new to me. It is much larger, looks like 22mm, still bit of pipe with an olive at the end, but as the pic shows, it doesn't seem to have been screwed onto the radiator but seems like an extension of the radiator. The nut is too big for the valves I have. How do I connect it to the valve? Why is it so large here? I can't even unscrew from the rad to replace...

15mm.JPG


22mm.JPG
 
http://www.NoLinkingToThis/p/chrome-angled-radiator-valve-drain-off/70408
 
The Screwfix link helps, thanks. I suppose the TRV for the first pic would be 15mm at both ends?
I didn't know you could remove the valve stem. All of the radiators I've come across (i.e paid attention to) was like in the first pic.
I'll have a look inside the stem tomorrow.
Cheers guys. Always learning something new here.
 
Status
Not open for further replies.

Similar plumbing topics

S
    • Like
  • Question
A lot of plumbers do that yes but I'm not a...
Replies
2
Views
1K
  • Question
Or there’s no clip and overtime it’s dropped
Replies
3
Views
905
Thanks for the responses to my question, I...
Replies
11
Views
6K
https://www.plumbersforums.net/threads/problems...
Replies
6
Views
2K
Since it became normal for trv's to be bi...
Replies
1
Views
661
Back
Top