Hi
Can anyone advise how the copper push fit connectors work?
Is it a matter of just pushing in the pipe until it goes in as far as it can and are these connectors suitable for water and gas?
Also I see that there is a special tool to release the connector if you get it wrong or not quite right but is there an alternative way to remove it other than the special tool?
Are these connectors more reliable than using the polypipe push fits to copper, or are copper push fits more secure?
I understand copper pipe to Poly push fit don't need any insert, and assume the same with copper to copper push fit.
I've only just come across them, didn't even know they did copper push fits
Thanks
Can anyone advise how the copper push fit connectors work?
Is it a matter of just pushing in the pipe until it goes in as far as it can and are these connectors suitable for water and gas?
Also I see that there is a special tool to release the connector if you get it wrong or not quite right but is there an alternative way to remove it other than the special tool?
Are these connectors more reliable than using the polypipe push fits to copper, or are copper push fits more secure?
I understand copper pipe to Poly push fit don't need any insert, and assume the same with copper to copper push fit.
I've only just come across them, didn't even know they did copper push fits
Thanks