Corvec Brittony II Multipoint | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Corvec Brittony II Multipoint in the Plumbing Jobs | The Job-board area at Plumbers Forums

Messages
4
We have a Corvec Brittony II multipoint that will only ignite the main burners if the temperature control knob on the front of the multipoint is turned up to its maximum heat setting - making the water too hot to use. Do you know what the problem could be?
 
Ok 2 yr ago so it is not due a full service for another year then, Did you have the basic service done last year? I would still have a full service carried out by your local GSR as it sounds like it needs one & they could also see if anything else is wrong while they are there. I do suspect what is wrong with it but am not willing to share this due to people trying to have a go themselves at mending their own gas appliances by reading these threads. Not saying you would be that daft though. Hence the advice to have a full service done as what I think it is will be changed on a full service.
 
Thanks Darren, hopefully it is not a major component/problem then. Are you in the Kent area and if so what would be your charge for a full service.
 
Good advice from the guys above ^^^ , be aware some parts are getting hard to get hold of for these mulipoints , don’t throw a lot of money at it , it maybe time to change it depending on its age .
 

Similar plumbing topics

  • Question
What’s the flow rate out of the hot tap
Replies
11
Views
3K
Probably best to call Worcester Bosch to see...
Replies
1
Views
1K
That could work. Some timers are SPDT, so one...
Replies
9
Views
471
P
Hi, I have a new built house with the...
Replies
0
Views
973
PierpaoloB
P
Back
Top