Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Cutting copper pipe against wall

Status
Not open for further replies.
Hi, i need to make a tee section in a copper pipe for new hot/cold runs, however the pipes are against the wall and i cant get my pipe cutter all the way round. What's the best course of action?

See pic attached.
 

Attachments

  • Untitled-2.jpg
    Untitled-2.jpg
    84.9 KB · Views: 93
Grinder with one of these
http://www.NoLinkingToThis/p/titan-...tracking url&gclid=CIC-0M7r4tECFQs4GwodfRkF1A
 
Grinder with one of these
http://www.NoLinkingToThis/p/titan-...tracking url&gclid=CIC-0M7r4tECFQs4GwodfRkF1A
 
Re. Rothenberger branch former. I've used the REMS one, but only very occasionally. Also the branch needs to be brazed in, not soft soldered, and that close to a wall the extra temperature would a) scorch the wall, b) probably wreck the joints below.

Could use a wire hacksaw like Silverline Wire Hand Saw 330mm
 
Status
Not open for further replies.

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Back
Top