Don Gas Conversion

[moonlight]

Do any of you fine gas engineers know where I can buy a Eurosit valve for a Don gas conversion.
Details on valve are

DIN - DVGW 92.03c049
T amb 0 - 120 degrees C
TR bereich 100 - 340 degrees C
cod 0630201 data 9436
Lot 4046278 Nr 0137

I have found a few others on the net, but seem to be for fryers and some for ovens.

Hope someone can make me a sensible suggestion. Thanks

 

[ShaunCorbs]

for an aga ?

 

[moonlight]

Yes sorry forgot that bit of info

 

[ShaunCorbs]

try phoning these guys up

http://www.agafixspares.com/store/

 

[moonlight]

I looked on their website nothing looks the same.

Looks like I will be running around tomorrow

 

[lame plumber]

forget aga fix to bloody expensive.

ABGO or oilwarm in cullompton devon are both good £138 and 2 oven for £70 or so from abgo overnight. oil warm do burner bars etc that don use that no other beggar can supply, very helpful small firm.

you need to strip out the old pilot plug or you can buy a new one instead. buy the 4 oven to fit both models or the 2 oven only for the 2 oven, they look different as well but the 4 oven has a longer oven stat sensor vial on it. you want a eurosit 630, forget the rest of the bumph

be interested to know why your going for the gas valve, they rarely go wrong, normally another issue causes problems, but folks fooled into going for the valve, speaking from recent experience here

 

[moonlight]

Thermocouple has recently been changed. The aga stays lit comes to a reasonable flame, ( I know these take quite a while before you can bring them up to full flame) pilot comes and goes then drops out. As you say not much to go wrong no electrics etc. I drew the short straw my college retired Friday. I went along but it is his diagnosis.

 

[lame plumber]

rightyho, strip out the pilot burner assembly,clean it really well and clean the nozzle v carefully or replace the pilot burner , 1000 to one thats the issue, not the expensive gas valve. bugger waiting to bring burner to full flame, wack it mid point when its lit and check in 4 hours. So check the pilot flame is big enough that will be the issue it starts ok, keeps the thermocouple on and when it draws harder as it warms the pilot lifts off the thermo couple, so spent £8 with BES on a replacement pilot assembly before going for a new gas valve.

 

[moonlight]

I will give that ago first. Thanks

 

[lame plumber]

buy the right pilot assembly normally a 3 flame side entry for pipe