Dual immersion heater question

[shackec]

I recently posted to request information about supply of a "dual Immersion heater". Two members kindly replied with helpful advice.
I tried to respond with thanks but the system persistently refused to accept this; quoting:
"Your content can not be submitted. This is likely because your content is spam-like or contains inappropriate elements. Please change your content or try again later. If you still have problems, please contact an administrator."
I cannot find any way on the site to contact an administrator.
So, this is the only way I can say "thank you gentlemen"!
Your help is much appreciated.
Regards. shackec

 

[snowhead]

Forgot to mention yesterday, you'll need additional wiring between the On/Off- Bath/Sink switch and heater.
Currently between your existing switch and the heater (assuming you already have a single one) you will have L, N, E, for the Dual Heater you'll need L1, L2, N, E.

Not too much of a problem if the switch is at the location of the Immersion heater

 

[shackec]

Forgot to mention yesterday, you'll need additional wiring between the On/Off- Bath/Sink switch and heater.
Currently between your existing switch and the heater (assuming you already have a single one) you will have L, N, E, for the Dual Heater you'll need L1, L2, N, E.

Not too much of a problem if the switch is at the location of the Immersion heater

Thank you for the response