A
antsals
I'm after a little advice; I'm changing a radiator and need to extend a plastic pipe that is mounted behind dot and dab plasterboard. I don't really fancy channeling out all the pipe back to the joint; but I haven't been able to find any reference on the internet about jointing "in-wall" and then plastering over?
I was thinking cutting the small section of plasterboard out, then using a compression fitting or HEP02 fitting, sleeve with felt wrapping and then plaster back over?
Whats best practice in this scenario?
Thanks for advice,
Anthony
I was thinking cutting the small section of plasterboard out, then using a compression fitting or HEP02 fitting, sleeve with felt wrapping and then plaster back over?
Whats best practice in this scenario?
Thanks for advice,
Anthony