P
PSH
My Mother had her microbore system powerflushed a couple of years ago by "Powerflush Ltd" ,who did a marvelous job of cleaning out 40 years worh of sludge and got all her rads working again. The guy who did it, was honest enough to warn us that due to the microbore system having such stupidly tight bends and the huge amount of sludge in the system ,that more sludge could still be lurking and move around the system eventually causing one or two rads to run cooler over time . Sure enough two rads on the same run are now running luke warm, So I went into the attic and think i have found a small section of pipe on the return run from the problem rad where it bends around a tight corner just before it enters the manifold .With the help of a friend ,I am going to cut out the section where it suddenly goes from hot to cold and replace it . If we get it working ,I would like to know what you guys reccomend I put in the system afterwards to dissolve any remaining sludge, Fernox something or Sentinel something or what about Salamanda ? . Once I have run that around the system for a few weeks I would like to know what type of inhibitor I should use please. Also where is the best place to put the cleaner in the system, by draining the header tank and putting it in that way or drain a rad and putting it in there ?
Thanks .
Paul.
Thanks .
Paul.
Last edited by a moderator: