gas meter

[hammers4spanner]

new build house less than year old and open cupboard door with gas supervisor looking on and this what greets me lol

 

[Leo21]

A free manometer and hose?

 

[Dotty]

A free manometer and hose?

Hahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahahaha

 

[Simon F]

A bit close !
so what are the dates on the meters ???
Are the copper and clips colour coded to match the regulator?

 

[hammers4spanner]

reg to close to consumer unit new build house as well

 

[Resolute]

Stick a divider board under the consumer unit if it'll fit.

 

[Resolute]

Plus if that house is less then a year old why was the consumer unit signed off in 2009?!

 

[hammers4spanner]

house is first phase of new build linden homes , part of the allocated h/a on new build was first lai

 

[hammers4spanner]

unless its first year under a housing scheme

 

[Pssst]

ECV falling to on..

 

[Leo21]

ECV falling to on..

Bloody eagle eye!

 

[Howsie]

ECV falling to on..

Unless its off of course.

 

[Pssst]

Unless its off of course.

If its off,its probably passing..

 

[SafeGasInstall]

i never new there was grey copper pipe and clips

 

[SafeGasInstall]

earth clamp has ben painted so is NCS

 

[Crinkmeister]

Why on earth would anyone paint the gas pipe?!! (oops, no pun intended!!)

 

[Leo21]

You know I wouldn't mind, but that's better than I see on a daily basis.

 

[Howsie]

If its off,its probably passing..

Doubtful

 

[Howsie]

Why on earth would anyone paint the gas pipe?!! (oops, no pun intended!!)

Get a lot of that in newish builds. Hides the crap soldering an makes it look expensive.

 

[Pssst]

The on /off tape appears to be upside down.
If the handle can travel past the horizontal to point downwards then its clearly falling to on.

If the handle is in its horizontal stop position and needs to point up to be on then the on off tape is wrong and further,if thats the case,the handle has passed its horizontal position before stopping and so the stop pin is likely bent thus allowing it to overtravel past the horizontal leading to a possible passing when off situation. Painted pipes ? horrible..looks like cheapo new build. Hides all that self clean flux gunk which should have been wiped off.

 

[Howsie]

The on /off tape appears to be upside down.
If the handle can travel past the horizontal to point downwards then its clearly falling to on.

If the handle is in its horizontal stop position and needs to point up to be on then the on off tape is wrong and further,if thats the case,the handle has passed its horizontal position before stopping and so the stop pin is likely bent thus allowing it to overtravel past the horizontal leading to a possible passing when off situation. Painted pipes ? horrible..looks like cheapo new build. Hides all that self clean flux gunk which should have been wiped off.

Looks horizontal to me

 

[Crinkmeister]

Doesn't the gas supply pipe usually come up from the floor?

 

[SafeGasInstall]

public forum here lads

 

[bewsh]

ECV falling to on..

Would you say this is NCS or AR?

 

[AWheating]

Would you say this is NCS or AR?

a problem for the grid man