Gas sniffer / detector - what have you got, what is good?

[Masood]

I've got a Kane GLD450 that came with my FGA but no idea whether it is particularly accurate or sensitive? Used it a few times and it has found a leak, but a few times, it has detected "leaks" where there's been no drop on the gauge, and LDF hasn't shown anything.

What do you use? What would you recommend?

 

[Dotty]

I use a tpi one which is fairly good, needs new batteries while I think about it...

 

[Dotty]

This one, Mas.

TPI 719 Combustible Gas Leak Detector (30ppm Sensitivity)

 

[Masood]

30ppm is pretty sensitive!

 

[Dotty]

It's not bad!

 

[GrahamM]

My Anton AGM 50 is the dogs!
Saved me so much time on the smallest of leaks that LDF has trouble indicating.

 

[Robert Tyrrell]

I use the Honeywell one and find it to be great as its picked up a few leaks (Not my work) that pdf didn't

 

[ambrosia]

currently using the same one as Croppie, but dont really like it, its sometimes too sensitive, only works on lowest setting otherwise it just goes off constantly, also when you 1st turn it on you have to wait ages for it to settle, usually you have to take it out and wave it about

Before i had an attachment for an Anton FGA which was much better, only problem was it used to cain the battery

 

[Dotty]

currently using the same one as Croppie, but dont really like it, its sometimes too sensitive, only works on lowest setting otherwise it just goes off constantly, also when you 1st turn it on you have to wait ages for it to settle, usually you have to take it out and wave it about

Before i had an attachment for an Anton FGA which was much better, only problem was it used to cain the battery

I've changed my mind about it. The sensor packed up in mine earlier this week.