Getting Air out of your system

[happyflyer]

Watch this and all your problems are solved, note the air scope above the pressure vessel
good little bit of kit


How to remove the air from your boiler / heater - YouTube

 

[Koogatubac]

God
I was bored after 2mins

 

[happyflyer]

God
I was bored after 2mins

That's why I put it there, I was too, didn't understand a word the guy said

 

[AlexGas]

DIY!

How to solder copper pipe - YouTube

 

[happyflyer]

Do you guys use oxy acetylene, I don't think so and the end he didn't sweat up would be all tarnished, dope.

 

[Keefy]

God
I was bored after 2mins

I managed nearly 5 minutes and he still hadn't gotten round to what he was supposed to be talking about. Bored me to death.

Why can't yanks say 'solder'? Sodder, sarder...

 

[Dotty]

I managed nearly 5 minutes and he still hadn't gotten round to what he was supposed to be talking about. Bored me to death.

Why can't yanks say 'solder'? Sodder, sarder...

I switched off soon as he opened his gob.

 

[happyflyer]

I switched off soon as he opened his gob.

Do you think he would be gas safe Croppie ???

 

[PlumbBobBob]

i only lasted 43 seconds lol

 

[Keefy]

Sodder, sodder.

I can't stop saying it.

 

[Koogatubac]

Wat a id - oxy-ath soldering? The joint was black and dirty!
"Cant have too much flux" he obv doesnt have a clue in the jointing process... Idiot DIYer

 

[Dotty]

Do you think he would be gas safe Croppie ???

I doubt he's even water safe!

 

[zzzjim]

air scope above the pressure vessel

Thanks for Accent warning , most EVs iv'e seen mounted other way up ,so trapped air gets at rubber !

Other than Hydrogen filled system, I had pondered if rubber diaphram would last longer ?

 

[Crinkmeister]

I thought the copper toob was going to melt.:biggrin5:

 

[Keefy]

I thought the copper toob was going to melt.:biggrin5:

I've melted a cheap solder ring fitting before now, it just disintergrated, literally began to disappear when I put the blowtorch on it.