Giving Gastite a try | Gas Engineers Forum | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

  • Thread starter Mike Jackson
  • Start date
  • Replies 9
  • Views 195

Discuss Giving Gastite a try in the Gas Engineers Forum area at Plumbers Forums

Status
Not open for further replies.
M

Mike Jackson

Priced a job up to use tracpipe across a loft and checking prices discovered that BES are knocking out a 25mm x 15m Gastite contractor kit for £176.74 plus the dreaded as opposed to £240.86 plus for the Tracpipe. Be rude not to try it, especially as it leaves me £70 better off.
 
And their to shirts are nice! Take it you cannot get croppa up there?
 
Very low pitch and customer wants pipe round edge so a real pain to solder.
 
Unfortunately, yes. Typical, that didn't come up when I searched earlier.
 
Make sure you get a freebie tshirt from gas totes site too :wink:
 
Ha ha no but I thought I'd try it and thought it wasn't bad at all
 
Looked at it because of the shirt but buying it because it's £70 cheaper than Tracpipe.
 
Status
Not open for further replies.

Similar plumbing topics

J
  • Question
To be fair some places in London have an...
Replies
2
Views
913
J
Replies
1
Views
700
J
  • Question
They sound extremely suspect, I realise it's...
Replies
2
Views
782
That looks like oil fit twin. Insides plastic...
Replies
2
Views
1K
    • Like
From this post, I think you’ve got a good...
2
Replies
47
Views
6K
Back
Top