Glow-Worm Fuelsaver Mk2 problem. | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

  • Thread starter dumkopf
  • Start date
  • Replies 2
  • Views 4K

Discuss Glow-Worm Fuelsaver Mk2 problem. in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
D

dumkopf

I've got a Glow-worm fuelsaver Mk 2, recently serviced (6 months ago).
It usually works great, but has just developed a habit of occasionally turning itself off for no obvious reason, including the pilot light going out, maybe once every two or three weeks. I can usually relight it straightaway with the two little buttons behind the swing-out control panel, but sometimes it won't relight at all, Then maybe after a couple of hours it relights first time, then is OK for another couple of weeks.
Any ideas what could be causing this and how to fix it?
Thanks.
 
dont know much about the glow worm but sounds like a thermocouple problem to me. cheap repair if it is
 
Status
Not open for further replies.

Similar plumbing topics

  • Question
Update: I put up with the kettling noise for...
Replies
3
Views
2K
Hi Have a Glow worm Flexicom 30cx-Installed...
Replies
0
Views
981
After a bit of tinkering with the mid position...
Replies
4
Views
3K
I just repeated this test. This time I got a...
Replies
6
Views
3K
  • Locked
Ah the good old ' should be a doddle but ends...
Replies
2
Views
4K
IDCHAPPY
I
Back
Top