Got to replace this.

[rocketmanbkk]

Hi

I've got to replace this pipe.

Needs a branch fitted with 2x 40mm adaptors for bath & shower wastes.

Not tackled one before. Nothing wrong with it other than paint all peeling so custard wants it looking nice.

It goes into ground at drain. I was thinking to cut it above ground & fit straight connector, pipe to branch, branch, drill & fit adaptors, further pipe up to offset, fit offset, pipe & top cap.

The clips are in place & undo.

Am I looking at problems or maybe I'm overthinking it again?

I was looking at push fit?

Cheers

Suns coming out

Rct

 

[stani]

Can't see anything!

 

[rocketmanbkk]

 

[ShaunCorbs]

if it was me cut flsuh with deck and bang one of these in

http://www.mcalpineplumbing.com/was...s/drain-connectors/drain-connector-black.html

but be careful as it might be a back inlet gully (the pipe might pull out)

then carry on in black

and i would try and get the two 40mms close to clip them

 

[rocketmanbkk]

So the first one? It just pushes in & pipe up from there?

What do you mean about the 40mm?

Strap boss's?

 

[ShaunCorbs]

So the first one? It just pushes in & pipe up from there?

What do you mean about the 40mm?

Strap boss's?

depends if you can get rubbers and what soil if it is (if its terrain best to do what i said)

 

[rocketmanbkk]

Ok thx. It's only water, no toilet waste.

 

[ShaunCorbs]

Ok thx. It's only water, no toilet waste.

it will be a back inlet gully then, the only thing what will hold the bottom of it in place will be the cement so might be worth redoing it (if you get what i mean)

 

[rocketmanbkk]

I see, so pull it out, chip concrete out & put new in. Should be able to do that.

Do I put the new pipe in until I can't push no more or will it have like a hole to put it in if you get my drift.

 

[ShaunCorbs]

I see, so pull it out, chip concrete out & put new in. Should be able to do that.

Do I put the new pipe in until I can't push no more or will it have like a hole to put it in if you get my drift.

yea and you will have to see about dept as there are different types mark the existing on before you take it out will give you an idea

 

[rocketmanbkk]

Ok, cheers. Thx