hand drilling and tapping set for 1/8th and 3/8th | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

hand drilling and tapping set for 1/8th and 3/8th

Post thread

Discuss hand drilling and tapping set for 1/8th and 3/8th in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
Gasmk1

Gasmk1

Esteemed
Gas Engineer
Messages
2,155
open to offers for this Abbirko drilling and tapping set for inserting test nipples into steel pipe. open to offers will suit commercial gas engineers. i am manchester/warrington based

item no longer needed
 
Status
Not open for further replies.

Similar plumbing topics

K
Smart Pump Setting with gravity fed system
Everything working fine on PP mode - thanks...
Replies
7
Views
1K
Kingfisher1
K
G
New UPS3 pump too powerful ?
A simple thing i'd probably check is the...
Replies
9
Views
1K
Zippymark
Z
MarkWillGreen
Add underfloor to S-plan - S-plan+? closely spaced tees? new boiler?
Anyway, you can always increase the boiler...
Replies
16
Views
2K
John.g
J
david_navigator
Replace 2 meters with 1
Whereabouts are you based
Replies
2
Views
1K
Gasmk1
Gasmk1
Z
Low gas pressure during boiler full load test
Absolute cock & bull from SGN, think about...
Replies
8
Views
2K
gmartine
gmartine
Back
Top