heating doesnt get to max temp then cuts out...help | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss heating doesnt get to max temp then cuts out...help in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
M

Mobileghod

the boiler works fine until the heating gets to a tempertaure then cuts out. its not the max temperature they are used to?

any ideas where o start looking

thanks
 
Do you mean that the air temperature in the house doesn't get hot enough or that the water in the radiators doesn't get hot enough? Does the hot water in the cylinder get hot enough for a bath? Any idea on the boiler?
 
boiler is a glowworm he says that the boiler runs the heating when switched on at the programmer then after 10 mins it kicks out again the he has to keep resetting it!?!?!
#
you reckon i need to drain down flush out and get all the air out of the system again?
 
Status
Not open for further replies.

Similar plumbing topics

  • Question
Hi, I have I blend valve from Nu-Heat ( they...
Replies
0
Views
776
Yes and you can go even further add an outside...
Replies
1
Views
1K
C
I’m not posting here to agree to do/looking...
Replies
1
Views
847
Heating will run until hot gets up to...
Replies
1
Views
976
Is it a heat only boiler?, you say a new pump...
Replies
1
Views
582
Back
Top