Help - Advice on reloacating w/c waste pipe | Plumbing Jobs | The Job-board | Plumbers Forums
Guest viewing is limited

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Help - Advice on reloacating w/c waste pipe in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
D

darrena

Hi
I am about to fit a concealed cistern in our downstairs cloakroom.
As we need to make the most of what is a pretty small room we have purchased a compact unit that only requires 8cm clearance.
The w/c in this room has a waste which goes down in to the concrete floor and off to one side to join up with the main waste pipe which is in a cavity in the wall next to the cloakroom.

to optimise the use of the compact cistern the waste pipe will need to move back about 4 inches in to the wall cavity. To do so I will need to chisel the concrete floor up and slightly amend the direction of the waste pipe. I appreciate to most this is a big job for a small gain but I just wanted to check that there isn't any reason why I should proceed with this job that I haven't thought of apart from the overall effort!
All hot and cold water supplies come from above and from what I can see the radiator pipe are in the wall cavities.
The pipe turns horizontally about 25cm down
The house is 14 years old

Thanks in advance for your help
 

Attachments

  • 20160906_185159_resized.jpg
    20160906_185159_resized.jpg
    95.3 KB · Views: 14
  • 20160906_185135_resized.jpg
    20160906_185135_resized.jpg
    98.2 KB · Views: 16
  • 20160906_184952_resized.jpg
    20160906_184952_resized.jpg
    96.7 KB · Views: 14
Yes, it's a good idea to move it and make more space. In fact, it looks like it may pass right under where you need it.
Otherwise, it's chisel up a large hole and move with bends etc. On a relatively new house, it shouldn't be that hard!!
 
Status
Not open for further replies.

Similar plumbing topics

10 o’clock / 45 degrees would be better than...
Replies
3
Views
686
Thanks mate for the reply. Unfortunately the...
Replies
5
Views
2K
  • Question
You should be ok then but still allow rodding...
Replies
4
Views
951
Well persevered, it is always worth the extra...
Replies
4
Views
1K
Back
Top