Help, fitting a radiator in the loft. | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

American Visitor?

Hey friend, we're detecting that you're an American visitor and want to thank you for coming to PlumbersTalk.net - Here is a link to the American Plumbing Forum. Though if you post in any other forum from your computer / phone it'll be marked with a little american flag so that other users can help from your neck of the woods. We hope this helps. And thanks once again.

Discuss Help, fitting a radiator in the loft. in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
Messages
4
Hi, I am new to this forum and hopefully somebody can tell me if I can or can't do this. Here it is.
20171119_180640_zpscfzc4qcj.jpg
I want to fit a radiator in the loft and thinking to fit new pipes to the existing pipes which goes to my bathroom radiator. Just want to know is this ok or a bad idea. See photos
20171120_124202_zpsondgv2g1.jpg
Any advice much appreciated.
I cannot access central pipes without lifting up the floor in corridor and that is just too much work, really don't want to do that.
Thank You for reading my post, much appreciated.

DJ
 
Do you know what system you have ? Combi cylinder etc
 
What you want to do should work assuming smallest pipe size is 15mm. Things to look out for:
1. If the pipes marked "central heating" in your diagram are 22mm should be no problem. If 15mm, then if they are feeding more than the bathroom and loft radiators might be on / over the limit of heat that 15mm pipework can carry.
2. If you have an open vented central heating system (small tank in loft) the base of that tank must be higher than the top of the loft radiator.
 
Hi steadyon.
1. Yes, the pipe to bathroom radiator is 15mm, however, I cannot see main pipe (central heating). Im off to work now but tomorrow I will lift up more floorboards to see if I can access and measure the main pipe. Hopefully its 22mm.
2. No, mine is a combi boiler with pressurized system, is it a problem for my project?

Dont know if it's important but forgot to mention. Boiler is on the ground floor, bathroom on the 1st floor and loft 2nd floor.
 
Last edited:
Combi is not a problem for what you propose. Should all be OK across ground, 1st and 2nd floors.
Great, thank you very much.
After all fitted and tested for a period of time I will come back to give feedback with any issues, hopefully none. :)

DJ
 
Status
Not open for further replies.

Similar plumbing topics

Size of bathroom 230cm x 210cm Height 230cm...
Replies
0
Views
601
  • Question
Thanks Shaun, I need to investigate. I visited...
Replies
2
Views
767
  • Question
Hi all, hope this is okay to post. Just over...
Replies
0
Views
182
  • Question
Rough rule of thumb would be- If the pipes are...
Replies
3
Views
991
TBSE is good practice! As long as flow is the Top.
Replies
3
Views
853
Back
Top