E
Essex Mark
Hi all
Purchased Hilmor GLM pipe bender a few months ago and used it a few times, just lately I have noticed that when I use machine to bend 15mm copper tube, the tube comes out slightly squashed and mis-shapen with distinctive ridges around edge and the back of the 15mm roller is rubbing against the inside of the 22mm former, i know that throating is where the roller or guide is too loose but i sem to have the opposite problem, I have checked all the bolts and they seem to be tight and the rollers are oiled and spin round..... what can i do to loosen it up.
Purchased Hilmor GLM pipe bender a few months ago and used it a few times, just lately I have noticed that when I use machine to bend 15mm copper tube, the tube comes out slightly squashed and mis-shapen with distinctive ridges around edge and the back of the 15mm roller is rubbing against the inside of the 22mm former, i know that throating is where the roller or guide is too loose but i sem to have the opposite problem, I have checked all the bolts and they seem to be tight and the rollers are oiled and spin round..... what can i do to loosen it up.