Hive Installation help

[nmlyons31]

I'm replacing my multi-zone Danfoss controllers with Hive, so far the downstairs Hive receiver is wired in and working well. I'm having a problem wiring in the Hive Single Channel receiver to replace a Danfoss TP 4000 for the upstairs zone.

The TP 4000 is battery powered and has 2 connected wires to COM and N/O please see attached image.

Hive wiring diagram for your information

I'm aware that I need to

1. connect the brown COM cable to pin 1 on the Hive and create a bridging cable from 1 to L
2. connect the black N/O cable to pin 3
3. connect the spare grey to N

The problem I have is that the grey is not currently connected to anything at the other end, I've done a continuity check and traced the wire back to the main terminal, but I don't have any idea where to connect it.

Any help would be great! If you need any more info please ask.

Thanks

 

[ShaunCorbs]

Connect it to the blue wires in the back eg neutral cylinder end

Then stat end

Grey neutral
Brown live
Link live to common
Black to 3

 

[nmlyons31]

Connect it to the blue wires in the back eg neutral cylinder end

Then stat end

Grey neutral
Brown live
Link live to common
Black to 3

Brilliant.
All up and running.
Thanks for your help