Hot water/Tap problem. | Bathroom Advice | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Hot water/Tap problem. in the Bathroom Advice area at Plumbers Forums

V

vaughan

Can anyone tell me why after a baths been run, and I put the hot tap on in the kitchen, the hot water starts running again in the bathroom. system is a combi boiler.
Any idear's?
 
Last edited by a moderator:
If I previously remember reading correctly, this may be caused by 'back-flow' pressure? Probably need to replace the hot water valve/washer on the bathroom tap but I'll let other's comment.

I think you can get a similar problem on toilet cisterns letting in additional water when a cold water tap is opened. Usually the diaphragm washer needs replacing.
 
i've seen this happening before with lever taps. it will be a quarter turn valve, take the tap head off, there maybe a gland nut which you can tighten, if not then replace the tap valve with a new 1/4 turn valve.
 

Similar plumbing topics

C
  • Question
Thanks for replying matey. You've been a...
Replies
3
Views
1K
  • Question
What type of cylinder do you have?
Replies
6
Views
1K
  • Question
Not to my knowledge but they're not things I...
Replies
4
Views
1K
L
That shouldn't happen. Going to need lots of...
Replies
1
Views
317
  • Question
I think 2.7LPM is the minimum requireed so...
Replies
4
Views
379
Back
Top